La plate-forme collaborative de bricolages scientifiques et pédagogiques

Réalisation - Humming simulator

  • Etape 1

    [A] Lay the elastic flat and measure it. Add 3cm to this measure.

     

    [B] Cut a 'D' shape in the cardboard with the lower edge lengh maching the point A result.

     

    [C] Pinch a peg at each bottom edge end of the cardboard.

     

    [D] Attach the pegs to both sides of the cardboard with white glue.

    {#lang_bricoWikiWarnings_warning} Wait 15 minutes to allow the glue to dry.

     

    [E] Pass the string through the metal spiral of one of the peg and make a big knot on the other side.

     

    [F] Stretch the elastic and run it around the two pegs. Place it parallel to the bottom edge of the cardboard, very slightly on top of the cardboard (it should not touch it).

     

    [G] Decorate the cardboard on both sides with an image evoking bees (swarm, hive, etc.).



0 Commentaire(s) | Ajouter