Etape 1Pass on each long bolt a nut and a washer until the specified position (see illustration).
|
Etape 2
Place gas stove adapter on the nuts and washers.
Secure it with a new series of washers and nuts.
Tighten all securely using two wrenches.
|
Etape 3
Screw a nut onto each end of the long bolts.
bend the ends of the two metal wires.
Tighten the wires between nuts and cap nuts to form 2 parallel bars (see illustration).
Glue the feet of the structure on a piece of tile using two component glue (epoxy-Araldit).
Allow to dry.
|
Etape 4
With a box cutter, cut out 4 small rectangles of balsa.
Form a turbine by pasting the four parts (flaps) around a small plastic tube (with universal glue e.g. Cementit) .
|
Etape 5
Pass the steel rod (bar) in the center of the turbine. Slide on both sides and a plastic pearl.
Glue the pearls on the bar leaving just enough room for the turbine to turn freely.
|
Etape 6
Punch a very small hole in the center of the lid of the box.
Punch from the inside to the outside of the lid.
|