Réalisation - Solar house
Etape 8
Remove the solar light parts to clear the cell of its support (varies depending on the model).
Cut the electrical wires of the photovoltaic cell, leavign 2 cm attached to it. Strip the ends and twist the wires.
Extend the two electrical wires with about 10 cm of extra wire. Connect them by twisting them together and isolating them with thermal glue or insulating tape.
With an awl, make a hole near the top of the roof. Run the wires through the hole. Paste the cell on the roof with hot glue.
Connect the led/battery pack of the solar lamp to the 2 wires coming from the cell (as it was previously connected). Paste the led/battery under the roof with hot glue.
Place the House on its base (do not paste) and then paste the greenhouse with thermal glue or other universal glue.
Press the steak thermometer so that its tip comes out in the greenhouse. Screw or glue the spring clip on the roof below the photovoltaic cell.